Install the Battery

Before using your Gel Blaster, install the battery according to the battery compartment location shown in the included user manual.The battery should be charged using the included USB charging cable 1.Make sure the battery is securely connected. 2.Turn on the Gel Blaster and check whether it has sufficient power. 3.Perform a basic function test before loading gel beads.

Prepare the Magazine

Before loading the magazine, make sure the gel beads are fully expanded.

Load gel beads through the large loading opening located at the bottom of the magazine.

Important:

Do not load gel beads through the feeding port.

The feeding port is designed for transferring gel beads from the magazine into the Gel Blaster.

Loading gel beads through the feeding port may cause:

• Feeding problems;
• Blockages;
• Difficult cleaning.

After loading gel beads correctly, the magazine is ready for installation.

Load Gel Beads Into the Chamber

After installing the magazine:

Pull the loading handle according to your Gel Blaster model.

You may hear the gel beads moving from the magazine into the feeding system.

This indicates that the Gel Blaster is preparing gel beads for operation.